Step 7, Secure Refrigerator; Step 8, Adjust Door Swing; Step 9, Install Grille Panel - Monogram ZlS360N Installation Instructions Manual

Installation Instructions
ISTEP71
SECURE REFRIGERATOR
TO CABINETRY
_'_ henexer possible, i)erfiwm this step for anti-tip
security or when anti-tip brackets cannot be used,
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Drill hole in trim and drive screw through the trim
into ac!jacent cabinet.
• Follow the same procedure on the opposite side.
ThroughCaseTrimInto
AdjacentCabinets
ISTEP 81 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fldlv to 130 °, you may change the door swing to a 90 °
opening. Skip this step if door opening is satisfactory
for your installation situation.
130°
Door
Hinge
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is thcto_ T installed
in the 130 ° position.
• (:lose the door. From belo_, use pliers to tlIISCI'ew
the door stop and reinstall into the 90 ° position.
[STEP 9] INSTALL GRILLE PANEL
To insert fl'amed or o_erla) panel into the grille:
• Raise the grille panel to stop position.
L00_
Side
Trim
Screw
Adjust Nut Below
Spring to Accommodate
Panel Weight
Side
Trim
Screw
• I,oosen screws on side trim behind frame. Remoxe
bottom trim.
CAUTION: p.,.e, ,.,... ,.e
slippery. Grip metal panel firmly; so the panel does
not slip out of the fl'ame and cause personal i_wry
or damage to the fl'ame.
PRUDENCE •
• I,e panneau en m_tal
peut b&tre glissant. Tenir fermement le panneau en
m_tal, de mani&re _'lce que le panneau ne glisse pas
en dehors du cadre en provoquant des blessm'es
corporelles
ou des dolnlnages au cadre.
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
• A(!just the hinge spring to accommodate the panel
weight, if necessary.
14