Clearances; Electrical And Water Connection Location - Monogram ZIRS36N LH Installation Instructions Manual

Installation Preparation
36" Stainless Steel Refrigerators, Freezers
Clearances
Min. to
130° Door Wall
Swing
""130 ° "_{':')
, 90° Door Swing
,.
[__
i,
J i36-3/4"
'\\
....... --1 ,"._
4"_Min.
to Wall
Factory set for a 130° door swing. Order WX14X99
adjustable door stop to reduce swing to as little
as 90 °.
When Installed into a corner:
Allow 25" for a full 130 ° door swing. Allow 15" for pan
removal. Allow 4" min. clearance when door swing is
adjusted to a 90 ° opening for pan access, but pan
removal is restricted.
--25" H
Min. to 130° Door 130° Door
Wa Swing Swing
,,1 I I
// 1-' '-r
:::!:::::i::x ,,"
,/
"--. ........ j/j
25 _'_
Min. to
Wall
[,,
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door
swing product, no clearance between the units is
required. Order ZUGSS Stainless Steel Unified Grille
Panel Kit for one continuous grille panel.
2"
H _15'%
•)\ ! J\
• ','-[ \\ '\
\\
\\
\,'\
, \\ %
"'.. .;,_: "-.. .;,,_
Clearances for two products installed side-by-side
with the same (left or right) door swing
Allow 2" minimum clearance between the products
to prevent door swing interference. Order the
WX14X99 adjustable door stop to reduce the factory
set 150 ° door swing. Allow 15" minimum to a wall to
achieve full drawer extension and pan removal.
NOTE: ZUGSS Grille Panel Kit will not fit this
installation.
5"
! '\/' !
'-i \v:':,i' ]"
A A /
////'\ \ /
/ / \ ',, /
'_ , //'// \,'\\, jJ
Clearances for two products installed side-by-side
with right and left side hinges together
Allow 5" minimum between the two products to
prevent one door from striking the othen Use the
WX14X99 adjustable door stop to reduce the factory
set 130 ° door swing and to allow pan removal.
NOTE: ZUGSS Grille Panel Kit will not fit this
installation.
Electrical
end Water
Connection
Locations
The water line can be routed through the floor or
back wall.
• The icemaker water line should be:
- Approximately 3-1/2" from the floor on the back
wall, or 3-1/2" from the back wall on the floon
- At least 5" from either side of the opening.
A 115 volt, 60 Hz 15 or 20 amp power supply is
recommended. An individual properly grounded
branch circuit or circuit breaker is recommended,
as noted on the rating plate.
• Locate the electrical outlet within 5" x 6" shaded
area shown.
- 2-1/2" from the left side.
Between 75" and 81" from the floon
IMPORTANT: To insure a flush fit and access to the
power cord, locate the electrical outlet as shown.
Electrical Outlet
Location 2-1/2"
y6I
Water Supply |
3-1/2" / \ 3-1/2"|
3-1/2"
75"