Step 5: Level Refrigerator - Monogram ZIRS36N LH Installation Instructions Manual

Installation
36" Stainless Steel Refrigerators, Freezers
Step 5
Level
Refrigerator
These products have a A-point leveling system.
The front is supported by leveling legs, the rear is
supported by wheels.
• Adjust rear wheels beneath the product to just
barely touch the 2x4 block.
• Turn the 7/16" hex nut located above the front
wheels. Turn to raise or Iowen
• For front leveling legs, use a 1-1/4" open-end
wrench.
• Adjust carefully; the product should be level and
plumb with cabinetry, and should align with toekick
height.
Hex Nut Adjusts _:::=_:_=411 i
RearWheels )l_Jl J
o ZOo o
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1". If
the installation requires more than 84-1/2" height,
the installer should elevate the refrigerator on a
sheet of plywood or runners. Cabinetry trim could
also be added across the top of the opening to
shorten the opening. If you attempt to raise the
refrigerator more than 1", you will damage the
front leveling legs and rear leveling wheels.
Les roues de nivellement arri@re et les pattes de
nivellement avant permettent un r6glage maximal
de 25 mm (1 po). Si I'ouverture pour le r_frig_rateur
a une hauteur sup&rieure _ 2,15 m (84-1/2 po),
I'installateur dolt _lever le r_frig_rateur sur une
feuille de contre-plaqu& ou des glissi@res. II est
_galement possible d'ajouter des baguettes de
finition des placards sur le haut de I'ouverture afin
de la r_duire. Lever le r_frig_rateur de plus de 25
mm (1 po) endommage les pattes de nivellement
avant et les roues de nivellement arri_re.
Step 6
Secure
Product
to Sides
NOTE: Whenever possible, perform
this step for additional anti-tip
security. This step can be used as
an alternate to Step 4, Anti-Tip
bracket installation, whenever
brackets cannot be used.
_/ Refrigerator \
Studj_LCabinet \
OR _
When using 1/2" to 3/4" side panels, the front flange
of the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim below interior opening. Drive screw
through trim and side panel.
• Follow the same procedure on opposite side.
If installed between cabinets with no side panels
or in a custom enclosure, install a spacer block as
shown.
• Open door to access case trim.
• Drill hole in trim below opening. Drive screw
through trim and into block.
• Follow the same procedure on opposite side.
11