Monogram ZIRS36N LH Installation Instructions Manual page 16

ZUGSS Trim Kit
Unified Stainless Steel Grille Panel
Step 4
Secure
Products
To Sides
NOTE: This step can be used
as an alternative to Step 2,
Anti-Tip bracket installation,
whenever brackets cannot
be used. Whenever possible,
perform this step for additional
anti-tip security.
When using 1/2" to 3/4"thick side panels, the front
flange of the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim slightly below the interior opening.
• Drive screw through the trim and into the side
panel.
• Follow the same procedure on the opposite outside
product trim.
_/ Refrigerator
Stud LLZ Cabinet \
xg:
OR _
If the product is installed between cabinets with
no side panels or into a custom enclosure, install
a spacer block as shown.
Step 5
Install Center
Trim Strip
• Open doors fully.
• Starting at the top, press trim strip over inside case
trims of both products.
• Continue pressing trim until you reach the bottom
of the case trims. The trim will align with the top
and bottom of the case trim.
CaseTrim
U-Shape
Trim
Step 5
Remove
Wire Fence and
Switch Cover
j_
j"
Grille Base Cover
• Remove 3 screws holding the wire fence on both
products. Retain fences and all screws.
• Lift off grille base covers. Discard covers.
16