Step 3: Install Side Panels; Step 4: Install Anti-Tip Brackets - Monogram ZIRS36N LH Installation Instructions Manual

Installation
36" Stainless Steel Refrigerators Freezers
Step 3
Install
Side Panels
• Side panels are required whenever the sides of
the product will be exposed and when installed
between frameless cabinets. See pages 3 and/4.
• Side panels are not required when installed into
an enclosure
• Side panel installation will be determined b U the
design of the side panel you have previously
chosen
• Side panels must be installed plumb
Illustration A
1/4" Side Panels 23-9/16"
Insert end of side
panel into case trim
84" "_2 9/16
Top View
Standard 4" high toekick or trim to fit Height may vary
depending on application
• If gou choose to use 1/4" side panels theg should
be inserted into the case trim as illustrated Fasten
the panels to the product with stick on hook and
loop fastener strips before setting in place See
illustration A
• 1/2" to 3/4" side panels are normallg set into
place and fastened to adjacent cabinetry or
the back wall before rolling the product into
the opening See illustration B
Illustration B 243/4
1/2" to 3/4" Side
Panels - Leading i
edge of side panel
is flush with cabinet
front Fasten to the
back wall using a
c_ _ 3 3/4
Top View
Standard 4" high toekick or trim to fit
Height mag varg depending on
application
Step 4
Install
Anti-Tip
Brackets
10
ANTI-TIP PRECAUTIONS
The refrigerator is top-heavg and must be
secured to prevent the possibility of tipping
forward.
PRECAUTIONSCONTRE LES BASCULEMENTS
Le r_frig_rateur est beaucoup plus Iourd en
haut et il faut le maintenir en place pour _viter
la possibilit_ de son basculement vers I'avant.
• Cut a 2"x 4"x 35" block and secure the block to
the mounting brackets provided using #12 or #14
wood screws
• Secure the bracket with wood block to the back
wall so that it is 84" (or gour installation height)
from the finished floor Use #12 or #14 wood
screws See illustration
• Screws must penetrate at least one inch into
vertical wall studs
• Before pushing the refrigerator into the opening
plug the power cord into the receptacle Open the
grille panel and reach into the opening at the back
to grasp the power cord Pull the power cord into
the opening as gou push the refrigerator back
• Gentlg push refrigerator into the opening with
hands against front corners
Brackets
Required
Height
From
Floor
to
Bottom
ofWood
Block
SideView
Brackets
NotRequired
Beneath a
Soffit
2 x 4 CutJ
35Length
Installation Mounting
Height Bracket
FromFloor
ScrewsMountedintoJ_
VerticalWall Studs
IMPORTANT NOTE: When the refrigerator is installed under
a soffit or if there is not enough height for this method of
securitg, brackets cannot be used. Proceed to step 5 to level
the refrigerator and then to step 6 to secure refrigerator to
cabinets. The refrigerator must be secured to prevent
tipping.