Monogram ZIRS36N LH Installation Instructions Manual page 17

ZUGSS Trim Kit
Unified Stainless Steel Grille Panel
Step 7
Install
Grille Base
Cover
Unified Base Cover
Place
9im Over
Hinges
• Open doors fully.
• Install the double width grille base cover by
slipping the notched ends over the hinges.
Install Install
3 Screws 3 Screws
• Place wire fence over the grille base cover (textured
side out). Drive original wire fence screws through
the fence, the grille base cover and into the frame.
Step 8
Remove
Grille Frame
• Back out 2 screws on each side of the top
case trim.
• The top piece is secured to the unit with a rubber
dust gasket. Roll the trim upward to access and
remove end screws as shown. Remove and discard
inside pieces.
• Slide assembly out of the rubber gasket.
Dust
6asket
Remove
Screws
17