Step 2: Install Water Line - Monogram ZIRS36N LH Installation Instructions Manual

Installation
36" Stainless Steel
Refrigerators,
Freezers
Step 2
Install
Freezer
Water Line
• A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 20 and 120 p.s.i.
• Route 1/4" OD copper or GE SmartConnect
TM
tubing
between house cold water line and the water
connection location
• Tubing should be long enough to extend to the
front of the freezer Allow enough to accommodate
bend leading into the water valve
NOTE: The only GE approved plastic tubing is
supplied in the GE SmartConnect
TM
Refrigerator
Tubing Kits Do not use any other plastic water
supply line because the line is under pressure at all
times Other types of plastic may crack or rupture
with age and cause water damage to your home
GE SmartConnect T" Refrigerator Tubing Kits are
available in the following lengths:
2' (06 m) WX08X10002
6' {18 m) WX08Xl0006
15' (46 m) WX08X1001g
25' (76 m) WX08X10025
Shut offthe main water supplg
Turn on the nearest faucet long enough to clear the
line of waten
Install a shutoff valve between the icemaker water
valve and cold water pipe in a basement or cabinet
The shut off valve should be located where it will be
easily accessible
NOTE: Saddle type shut offvalves are included in
many water supply kits but are not recommended for
this application
\ Waterline Tubing
• Install optional water filter in the water line near
the freezen A water filter is recommended in areas
where water supply contains sand or particles.
Installation instructions are packed with the filten
NOTE: Commonwealth of Massachusetts
Plumbing Codes 248CP1R shall be adhered to
Saddle valves are illegal and use is not permitted
in Plassachusetts Consult with your licensed
plumben