Step 9 Adjust Door Swing; Step 10 Install Grille Panel - Monogram ZISB36 Series Installation Instructions Manual

Installation Instructions - Standard Installation

STEP 9 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop: 90°,
115°, and 130°. When space does not allow the door to
swing open fully to 115°, you may change the door swing
to a 90° opening. A 130° door swing option is available
for standard installation only. Skip this step if door
opening is satisfactory for your installation situation.
• Open the door to view the bottom hinge. Note the door
stop pin locations. The pin is factory installed in the
115° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 130° or 90° position.

STEP 10 INSTALL GRILLE PANEL

To insert the framed or overlay panel into the grille:
• Raise the grille panel to the stop position.
Loosen
Side
Trim
Screw
Adjust Nut Below
Spring to Accommodate
Panel Weight
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
CAUTION
The metal panel may be slippery. Grip the metal
panel firmly so the panel does not slip out of the
frame and cause personal injury or damage to the
frame.
ATTENTION
AUX ARÊTES VIVES
Le panneau en métal peut bêtre glissant. Tenir fermement
le panneau en métal, de manière à ce que le panneau
ne glisse pas en dehors du cadre en provoquant des
blessures corporelles ou des dommages au cadre.
Loosen
Side
PRECAUCIÓN
Trim
Screw
Es posible que el panel metálico esté resbaladizo. Tome
el panel metálico de manera firme, de modo que no se
deslice fuera del marco y ocasione lesiones personales o
daños sobre el marco.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
20
SHARP EDGE HAZARD
RISQUE DE COUPURE : ATTENTION
RIESGO DE EXTREMO FILOSO
31-1000450 Rev. 1