Fluke PM2811 User Manual page 83

Using your Programmable Power Supply
Remote sensing (outputs in parallel):
The sense wires are connected from the load to the +S and -S terminals of output
channel 2. This compensates for the voltage drop in the wires from the load to the
+V and -V terminals. The following diagram shows the wiring scheme.
OUTPUT 1
TWISTED
PAIR
OUTPUT 2
Figure 5.6.2 Remote Sensing with Two Outputs in Parallel
CAUTION: To prevent noise pickup, twist the sense wires and shield them from
the environment.
+S
+V
V
S
+S
+V
V
S
+
LOAD
ST5873
5 - 31