Getting Started; Selecting An Output Channel - Fluke PM2811 User Manual

4 - 8

4.4 GETTING STARTED

The various parts of this tutorial must be executed sequentially. Before starting
with this tutorial, make sure the power supply is in the local state. If the supply is
in the remote state (REM is displayed), press
disappear, the LCL key is disabled remotely by the Local Lockout (LLO) command
from the GPIB controller.
If the display shows the measured output voltage and current of one of the output
channels, the power supply is in the OPERATE mode. Before starting with the
tutorial, set the power supply to the STANDBY mode by pressing
the OPR/STBY key.
Notes: • For multiple output models the selected output channel number n will
be displayed.
• For a single output model the number n will not be displayed.
4.4.1

Selecting an output channel

Make an output channel active as follows.
If you have a single output model, skip the first three lines of the following
sequence.
Press SELECT
The display then shows the selected output channel.
ENABLE
Press
DISABLE
The display shows:
OPR
Press
STBY
The display shows:
to select the desired output channel.
to enable the selected output (if not already enabled).
n S T A N D B Y
ENABLED n
to set the power supply to OPERATE mode.
n x x . x x V
ENABLED n
LCL . If the REM text does not
y y . y y A
Users Manual