Fluke PM2811 User Manual page 45

Getting Familair with the Power Supply
1) The CALIBRATION mode is entered when you turn on the power supply while
pressing the AUX key.
2) To unlock the keyboard, press the ENTER key for approximately 5 seconds.
8
LCL
11
STORE
12
RECALL
13
STEP
RESET
25
c) COUPLE PROTection of all output
channels.
d) Set STandBY AT Power ON behavior on or
off.
e) Adjust the CONTRAST of the display (0-9).
f) LOCK the KEYboard
g) Verify/set the GPIB ADDRESS (0 - 30).
h) Verify the identity and firmware version of
the power supply + its output channel(s).
i) Verify/set the CALlibration access CODE
Switch the power supply to local control.
Store the voltage and current settings of all
output channels (999 store addresses).
Recall the stored voltage and current settings
from all output channels (999 recall
addresses).
Step from one recalled group of settings to the
next group of settings.
Pencil point operation push button to reset the
power supply while power is on.
4 - 5
2)
.