Fluke PM2811 User Manual page 23

Introduction to your PPS
• ABORt
This subsystem is used for stopping the step function of the power supply.
• CALibration
This subsystem is used for calibration of the instrument. Your power supply
can be calibrated without removing the cover or removing the power supply
from your rack measurement setup. This feature allows you to calibrate the
power supply at its normal operating temperature. The recommended
calibration interval is one year. Refer to the Reference Manual for complete
calibration details.
• DISPlay
This subsystem is used to control the front panel display.
• INITiate
This subsytem is used to start up (initiate) the step function of the power
supply.
• INSTrument
This subsystem is used to control the instrument functions.
• MEASure
This subsystem is used to measure (readback) output voltage and output
current.
• OUTPut
This subsystem is used to control an output channel.
• SOURce
This subsystem is used for source and setting functions of an output channel,
such as : - source definitions
- voltage (protection) settings
- current (protection) settings
- automatic stepping
• STATus
This subsystem is used for handling the device-dependent operational and
questionable status information.
• SYSTem
This subsystem is used to handle system and control functions, such as:
- lockout front panel control
- define the 'power on clear' behavior
- request for status information
• TEST
This subsystem is used to test the instrument.
2 - 9