Using your Programmable Power Supply
5 - 3
5.3 REMOTE OPERATION
In the remote mode, pressing the front panel keys will have no effect on
programmed settings. It is, however, possible to view the actual settings on the
front panel display, by pressing the front panel keys SELECT, V, I, OVP, DELAY,
UNMASK, DISP, LCL, and AUX.
SCPI (Standard Commands for Programmable Instruments) is a standardized set
of commands to be used for remote control of programmable test and measure
instruments. It defines the syntax and semantics that the controller must use to
communicate with an instrument, and is implemented in the instrument's
firmware.
Please, read the users handbook 'Standard Commands for Programmable
Instruments? to get familiar with the SCPI and IEEE-488.2 standards. This
handbook can be ordered at your local Fluke representative. See Appendix A for
more information.