Fluke PM2811 User Manual page 69

Using your Programmable Power Supply
Local control (in CV or CC mode):
The voltage V
set
Example:
Press the V key to start the voltage setting.
Press the keys 3, . (dot), 4 and ENTER to enter the setting of 3.4V.
The current I can be set using the
set
Example:
Press the I key to start the current setting.
Press the keys 0, dot (.), 2, 3 and ENTER to enter the setting of 0.23A.
The overvoltage protection level OVP
the numeric input keys.
Example:
Press the OVP key to initiate the overvoltage setting.
Press the keys 7 and ENTER to enter the overvoltage setting of 7V.
The overcurrent protection can be enabled/disabled using the
Example:
Press the OCP EN/OCP DIS key.
IF OCP was enabled THEN OCP is disabled
IF OCP has been enabled, the annunciator above the text
An overcurrent or overvoltage trip protection can be reset by pressing the
key.
RESET
In the CV mode, the annunciator above the text CV will be displayed.
In the CC mode, the annunciator above the text CC will be displayed.
can be set using the
ELSE OCP is enabled.
The display of OVERCURRENT or OVERVOLTAGE will also
disappear.
key and the numeric input keys.
V
I key and the numeric input keys.
can be set using the
set
5 - 17
key and
OVP
OCP EN
key.
OCP DIS
OCP
will be displayed.
EN