Fluke PM2811 User Manual page 66

5 - 14
To protect the load against excessive currents, the maximum current I
programmed, and the overcurrent protection can be enabled.
To protect the load against excessive voltages, the overvoltage protection level
OVP can be programmed.
set
LIMITATIONS
The output power is limited by:
• the output specific maximum power P
I x V
set set
RESTRICTIONS
The output voltage is restricted by:
• the output specific maximum voltage, or
• the overvoltage protection level OVP
Note: When the output voltage exceeds the overvoltage protection level,
both the output voltage and current are reduced to zero.
The output current is restricted by:
• the output specific maximum current, or
• the programmed maximum current level I
Note: If the overcurrent protection has been enabled and the output current
exceeds the maximum current (I
are reduced to zero.
If the overcurrent protection has been disabled, the output current
will be kept at its maximum (I
voltage will not reach its programmed value (V
channel will go into the CC mode.
<= P
max
, according to the formula:
max
set
set
), the output voltage and current
set
). The consequence is that the output
set
Users Manual
can be
set
), and the output
set