Using your Programmable Power Supply
•
SOLUTION:
Press
AUX
Check that the AUTO STEP is OFF, or press the OFF (0) key to set the
AUTO STEP function off.
Press
ENTER
Press
SELECT
ENABLE
Press
DISABLE
Press
SELECT
ENABLE
Press
DISABLE
Press
SELECT
OPR
Press
STBY
Press
STEP
Press
2
The display reads:
LOOP:
ENDLOOP
Press
SELECT
The display reads:
Press
Remark: When the next step is executed, the next voltage and current
Automatic step function
Local control (automatic stepping):
The AUTO STEP function, the CONTINUOUS STEP function, the step interval
time, the START address, and the STOP address can be set via the
The automatic step function can be started by pressing the
to enter the STEP submenu.
ENTER
to leave the STEP submenu.
(only for multiple output models) to select output channel 1.
to enable output channel 1.
(only for multiple output models) to select output channel 2.
to disable output channel 2.
as many times as necessary to select output channel 1 again.
to make the OPERATE mode active.
to enter the step mode.
to select start address 20 of the list.
0
ENTER
1
S T E P
Press
if you want to see the actual voltage on output
V
channel 1 at the memory address as indicated on the display.
Press
if you want to see the actual current from output
I
channel 1 at the memory address as indicated on the display.
Press
to select the next memory address of the list.
STEP
Repeat this loop until step 40 is made active.
to select output channel 2.
2
S T E P
to leave the step mode.
setting in the list is made active and output on the selected
channel.
2 0
. . . . . . .
4 0 D I S
STEP
5 - 23
AUX
key.
key.