Fluke PM2811 User Manual page 76

5 - 24
Example:
• REQUIREMENTS:
Step automatically through the predefined list of voltage and current
settings stored at the memory addresses 20 to 40. When the end of the list
is reached, it must be started again at the beginning. The next voltage and
current setting must be output for channel 1 at an interval time of 5
seconds.
• SOLUTION:
Press
AUX
Press 1
Press
AUX
Press 5
Press
AUX
Press 1
Press
AUX
Press
2
Press AUX
Press
4
Press ENTER
Press
SELECT
ENABLE
Press
DISABLE
OPR
Press
STBY
Press
STEP
Press 2
The display reads :
Press
ENTER
• Check that the memory address is automatically incremented every
5 seconds on the display.
• Exit the automatic stepping by pressing the (backspace) key. The last
recalled voltage and current setting remain active.
to enter the STEP submenu.
ENTER
to set the AUTO STEP function on.
to set the TIME INTerval function.
ENTER to set the interval time at 5 seconds.
to set the CONTINUOUS step function.
to set the CONTINUOUS step function on.
to set the START AT function.
to set the start address of the sequence list at 20.
0 ENTER
to set the STOP AT function.
to set the stop address of the sequence list at 40.
0 ENTER
to leave the AUX menu.
(only for multiple output models) to select output channel 1.
to enable output channel 1.
to make the OPERATE mode active.
to enter the step mode.
0 to select start address 20 of the list.
1 S T E P
to initiate the automatic stepping.
T O 2 0
Users Manual