Cisco Aironet 1550 Installation Manual page 89

Chapter 2 Installing the Access Point
Ensure that all power sources have been disconnected from the access point.
Step 1
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Note
Open the hinged cover (see the
Step 2
instructions).
Place the two large reels with the small reels on top as shown in
Step 3
Align the screw holes in the large and small reels, and insert four attachment screws in each of the reel
Step 4
pairs. Tighten the screws to 3 to 4 in. lbs (0.34 to 0.45 Nm).
Remove the plug from the end of the SFP module, and insert the module into the SFP receptacle (see
Step 5
Figure
Figure 2-32
1 Not used
2 SFP module slot
3
Fiber reels (large reel with small reel on top)
OL-24247-01
If your access point contains a backup battery pack, you must depress the reset button for
10 seconds or more (see the
"Opening the Access Point Hinged Cover" section on page 2-13
2-32).
Fiber-Optic Cable Components
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
Connecting a Fiber-Optic Cable to the Access Point
"Disabling Backup Battery Power" section on page
4 Four screws for each reel assembly
5 Fiber-optic connector plug
3-10).
Figure 2-32.
for
2-43