Cisco Aironet 1550 Installation Manual page 73

Chapter 2 Installing the Access Point
The 1552C and 1552CU access points can be installed using the pole mount kit in special circumstances.
Note
Refer to
"Mounting the 1552C or 1552CU Access Point Facing Up in a Vault Application" section on page 2-33
for installation instructions.
To mount the access point, follow these steps:
Assemble the cable clamps to the clamp bracket on both cable brackets
Step 1
hand-tighten the nuts sufficiently to prevent them from falling off.
Figure 2-17
1
Step 2 Secure each strap bracket with two M8 x16 bolts (with lock washers) on each side of the access point
with the antennas facing down.
Nm).
OL-24247-01
"Mounting the 1552C or 1552CU Access Point on a Pole/Wall" section on page 2-30
Assemble Cable Brackets
M8 flange nut and flat washer
(Figure
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2
1
2 Cable Clamps
2-18). Only hand-tighten the bolts to 13 to 15 ft lbs (17.6 to 20.3
Mounting the Access Point
or
(Figure 2-17). You should only
2-27