Unpacking The Access Point; Package Contents; Tools And Hardware; Optional Tools And Hardware - Cisco Aironet 1550 Installation Manual

Unpacking the Access Point

Unpacking the Access Point

When you are unpacking the access point, do not remove the foam blocks attached to the antenna
connectors. The foam protects the antenna connectors during installation.
To unpack the access point, follow these steps:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container, and save it.
Step 2
Step 3 Ensure that all items listed in
or missing, notify your authorized Cisco sales representative.

Package Contents

The typical access point package contains the following items:
•
•
•
•
•
•

Tools and Hardware

The tools and hardware used to install the 1552 access point are described in:
•
•
•
•

Optional Tools and Hardware

The optional tools and hardware that can be obtained from Cisco are:
•
•
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-2
"Package Contents"
Access point
Cisco product documentation and translated safety warnings
Three liquid-tight adapters
Two-pin DC power connector
Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
Watertight cable glands for Power-over-Ethernet (PoE) ports (depending on the 1552 access point
model, 2 or 3 cable glands are provided)
Optional Tools and Hardware, page 2-2
Optional Tools and Hardware That You Supply, page 2-3
Pole Installation Hardware and Tools, page 2-3
Cable Strand Installation Hardware and Tools, page 2-4
Optional power injector (AIR-PWRINJ1500-2=)
Optional AC power cord
– 40-ft (12.2-m) power cord with North American plug (AIR-CORD-R3P-40NA=) for light pole
installations in the US and Canada
AC power cord, 40 ft (12.2 m) with European unterminated end (AIR-CORD-R3P-40UE=) for
–
light pole installations outside of the US and Canada
Chapter 2
are included in the shipment. If any item is damaged
Installing the Access Point
OL-24247-01