Configuring Option 43 For 1100, 1130, 1200, 1240, 1250, 1300, 1520, And 1550 Series Access Points - Cisco Aironet 1550 Installation Manual

Configuring Option 43 for 1100, 1130, 1200, 1240, 1250, 1300, 1520, and 1550 Series Access Points

Configuring Option 43 for 1100, 1130, 1200, 1240, 1250, 1300, 1520,
and 1550 Series Access Points
To configure DHCP Option 43 for Cisco Aironet 1100, 1130, 1200, 1240, 1250, 1300, 1520, and 1550
series access points in the embedded Cisco IOS DHCP server, follow these steps:
Enter configuration mode at the Cisco IOS CLI.
Step 1
Create the DHCP pool, including the necessary parameters such as default router and name server. The
Step 2
commands used to create a DHCP pool are as follows:
ip dhcp pool pool name
network IP Network Netmask
default-router Default router
dns-server DNS Server
Where:
pool name is the name of the DHCP pool, such as AP1550
IP Network is the network IP address where the controller resides, such as 10.0.15.1
Netmask is the subnet mask, such as 255.255.255.0
Default router is the IP address of the default router, such as 10.0.0.1
DNS Server is the IP address of the DNS server, such as 10.0.10.2
Add the Option 60 line using the following syntax:
Step 3
option 60 ascii "VCI string"
For the VCI string, use the value from
Step 4 Add the Option 43 line using the following syntax:
option 43 hex hex string
The hex string is assembled by concatenating the TLV values shown below:
Type is always f1(hex). Length is the number of controller management IP addresses times 4 in hex. Value
is the IP address of the controller listed sequentially in hex.
For example, suppose that there are two controllers with management interface IP addresses,
10.126.126.2 and 10.127.127.2. The type is f1(hex). The length is 2 * 4 = 8 = 08 (hex). The IP addresses
translate to 0a7e7e02 and 0a7f7f02. Assembling the string then yields f1080a7e7e020a7f7f02. The
resulting Cisco IOS command added to the DHCP scope is listed below:
option 43 hex f1080a7e7e020a7f7f02
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
F-4
Type + Length + Value
Table F-1. The quotation marks must be included.
Appendix F Configuring DHCP Option 43
OL-24247-01