Cisco Aironet 1550 Installation Manual page 79

Chapter 2 Installing the Access Point
Mounting the 1552C or 1552CU Access Point Facing Up in a Vault Application
To mount the 1552C or 1552CU access point on a horizontal surface in a below-ground vault location,
follow these instructions:
Step 1 Use the mounting bracket as a template to mark four screw hole locations on your mounting surface. See
Figure 2-23
mounting holes or the mounting slots.
Figure 2-23
1
2
Use four customer-supplied screws and optional screw anchors to attach the mounting plate to the
Step 2
mounting surface.
Note
OL-24247-01
for the mounting bracket screw hole locations. You can optionally use the individual
Mounting Bracket Position for Vault Mounting
1
2
Access point quick mount notch
Mounting holes
If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the
access point to the base.
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
3
1
3 Mounting slots (allows bracket rotation)
Mounting the Access Point
2-33