Connecting The Backup Battery Cable And Closing The Radio Cover; What To Do Next - Cisco Aironet 1550 Installation Manual

Connecting the Backup Battery Cable and Closing the Radio Cover

Connecting the Backup Battery Cable and Closing the Radio
Cover
To connect the backup battery cable and close the access point radio cover, follow these steps:
Carefully position the access point radio cover over the access point as shown in
Step 1
Step 2 Hold the radio cover upright while placing the edge of the radio cover on the top edge of the access point.
Step 3 Carefully push the backup battery cable connector into the internal battery connector (see
Step 4 Close the radio cover, while being careful not to pinch the backup battery cable.
Use a Phillips screwdriver to partially tighten each cover screw in the tightening sequence, starting with
Step 5
1, as shown in
Step 6 Repeat
(2.49 to 2.71 Nm).
Figure 4-4

What to Do Next

After you have completed the backup battery procedures, your access point is ready to be deployed.
Carefully read and follow the safety and installation guidelines contained in the
Guidelines" section on page 2-8
"Mounting the Access Point" section on page
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
4-6
Figure 4-4. Tighten each screw to 11 to 12 in. lbs (1.24 to 1.36 Nm).
Step 5 using the same tightening sequence to fully tighten each screw to 22 to 24 in. lbs
Radio Cover Screw Tightening Sequence
8
6
and the installation and mounting instructions contained in the
Chapter 4
1 9
4 10
2-14.
Installing or Replacing the Backup Battery
Figure 4-2.
Figure
3
5
7
2
"Installation
OL-24247-01
4-2).