Cisco Aironet 1550 Installation Manual page 76

Mounting the Access Point
The assembled cable mounting kit is shown from the top view of the access point
Step 4
Figure 2-20
2
1
Note
Note
For the 1552CU access point, continue with
Step 5
continue with
Mounting the 1552C or 1552CU Access Point on a Pole/Wall
The 1552C or 1552CU access point can be mounted on a wall, pole, or a below-ground vault location,
using the pole mount kit. You can use the mounting bracket as a template to mark the positions of the
mounting holes for your installation. You then install the mounting plate, attach the grounding lug, and
attach the access point when you are ready.
To mount the 1552C or 1552CU access point on a vertical wall, follow these instructions:
When installing the 1552C or 1552CU access point using the pole mount kit, the grounding lug and cable
Tip
must be attached to the access point before attaching the access point to the mounting bracket.
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-30
Clamp Brackets Attached to Cable Strand-Top View of Access Point
SS
Top view of access point
The strand support cable might have to be pulled away from the fiber or cable bundle. Be sure
to resecure the cable as necessary.
The strand support cable and the mounting hardware provide grounding for the access point.
Grounding the Access Point, page 2-41
1
TP
2 Cable strand bracket
Installing Antennas, page
and Powering the Access Point, page
Chapter 2 Installing the Access Point
(Figure 2-20).
2
2-36. For the 1552C access point,
2-45.
OL-24247-01