Using Show Commands To Display Modular Port Adapter (Mpa) Information; Using The Ping Command To Verify Network Connectivity - Cisco ASR 9001-S Hardware Installation Manual

Installing and Removing Modular Port Adapters
Use the show version command to obtain software version information for the installed modular line
Step 5
cards (MLCs) as well as interfaces available.

Using show Commands to Display Modular Port Adapter (MPA) Information

Table 3-4
information.
Table 3-4
Command
show running-config
show platform
show diag
show hw-module fpd location
<rack/slot/subslot>
show version
Table 3-5 show Commands to Display Modular Port Adapter (MPA) Information
Command
show controllers type
rack/slot/subslot/port
show interfaces type
rack/slot/subslot/port
show diag rack/slot/subslot/
show version

Using the ping Command to Verify Network Connectivity

The ping command allows you to verify whether a modular port adapter (MPA) port is functioning
properly and to check the path between a specific port and connected devices at various locations on the
network. After you verify that the system and the modular line card (MLC) have booted successfully and
are operational, you can use this command to verify the status of the modular port adapter (MPA) ports.
Refer to Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide and Cisco ASR 9000
Series Aggregation Services Router Interface and Hardware Component Configuration Guide for more
information on bringing up and configuring the Cisco ASR 9000 Series Router and the Cisco ASR 9000
A9K-MOD80G-H.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
3-10
describes the show commands you can use to display modular port adapter (MPA)
show Commands to Display Modular Port Adapter (MPA) Information
Type of Information Provided
Router's running configuration and interfaces available in the
system.
Router's installed linecard and modular port adapter (MPA) type,
slot, and state information.
Modular port adapter (MPA) type in that slot, number of ports,
hardware revision, part number, and EEPROM contents.
FPD version information of modular port adapters (MPAs) in the
system.
Cisco IOS XR software version, names and sources of configuration
files, and boot images.
Type of Information Provided
Network link status, register contents, and
controller chip errors.
Line status and data link protocol status for a
particular modular port adapter (MPA) port.
Statistics about data traffic sent and received by
the port.
Modular port adapter (MPA) type in that slot,
number of ports, hardware revision, part number,
and EEPROM contents.
Cisco IOS XR software version and boot images. show version
Chapter 3 Installing Modules and Cables in the Chassis
Example
show controllers GigabitEthernet
0/0/1/1
show interfaces GigabitEthernet
0/0/1/1
show diag 0/0/1
OL-26701-02