C H A P T E R 3 Installing Modules And Cables In The Chassis; 4-Port 10 Gigabit Ethernet Modular Port Adapter - Cisco ASR 9001-S Hardware Installation Manual

Chapter 3 Installing Modules and Cables in the Chassis
Figure 3-2
Table 3-1
Table 3-1
LED Label
A/L
STATUS

4-Port 10 Gigabit Ethernet Modular Port Adapter

The 4-Port 10 Gigabit Ethernet modular port adapter provides four cages for XFP Ethernet optical
interface modules that operate at a rate of 10 Gbps. The four XFP modules can be 10-Gigabit Ethernet
multimode or single mode connections.
Each XFP cage on the 4-Port 10 Gigabit Ethernet modular port adapter has an adjacent Link LED visible
on the front panel. The Link LED indicates the status of the associated XFP port, as described in
Table
Refer to
OL-26701-02
20-Port Gigabit Ethernet Modular Port Adapter
describes the 20-Port Gigabit Ethernet modular port adapter LEDs.
20-Port Gigabit Ethernet Modular Port Adapter LEDs
Color State
Off Off
Green On
Amber On
Off Off
Green On
Amber On
4-4.
Figure 3-3 for an example of the 4-Port 10 Gigabit Ethernet modular port adapter.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Meaning
Port is not enabled.
Port is enabled and the link is up. The MPA A/L LED will
blink green when there is traffic activity.
Port is enabled and the link is down.
Modular port adapter power is off.
Modular port adapter is ready and operational.
Modular port adapter power is on and good, and modular
port adapter is being configured.
Modular Port Adapters
3-3