Using Show Commands To Verify Sip And Spa Status; Using Show Commands To Display Spa Information - Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual

Checking the Installation
Note
If the SIPs and SPAs have not become active within three minutes, see
Step 2
Installation."

Using show Commands to Verify SIP and SPA Status

The following procedure uses show commands to verify that the new SPAs are configured and operating
correctly.
Use the show running-config command to display the system configuration. Verify that the
Step 1
configuration includes the new SPA interfaces.
Use the show hw-module subslot brief or show hw-module subslot status command to display all of
Step 2
the current SPAs and a summary of their status.
Use the show inventory command to display details about the installed hardware in the system.
Step 3
Use the show hw-module fpd command to verify the FPD version information of the SPAs installed in
Step 4
the system.
Note
For more information about FPD upgrades, see the "Upgrading Field-Programmable Devices" chapter
in Cisco IOS XR Interface and Hardware Component Configuration Guide at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/ioxsoft/iox34/cgcr34/index.htm
Use the show version command to obtain a few details on the installed SIPs and interfaces available.
Step 5

Using show Commands to Display SPA Information

Table 6-1
Table 6-1
Command
show running-config
show hw-module subslot brief
show hw-module subslot status
show inventory
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
6-8
New interfaces are not available until you configure them.
If a SPA does not meet the minimum FPD version required, it might not function properly. If you
receive an error message on the system console that there is an FPD image incompatibility, you
should upgrade the FPD image on the SPA.
describes the show commands you can use to display SPA information.
show Commands to Display SPA Information
Type of Information Provided
Running configuration on the router and the interfaces available in
the system.
Operational status of all SPAs in the system.
SPA type in the slot, number of ports, and hardware revision and
part number.
Chapter 6 Installing and Removing a SPA
Chapter 7, "Troubleshooting the
OL-17439-01