Removing A Cable-Management Tray - Cisco ASR 9001-S Hardware Installation Manual

Chapter 3 Installing Modules and Cables in the Chassis
Figure 3-7
1 Cable-Management Tray
Insert and tighten the captive screw(s) to secure the tray. (see
Step 3
Connect all the cables to the intended ports and pass them throught the cable management tray in an
Step 4
organized manner.

Removing a Cable-Management Tray

To remove a cable-management tray, follow these steps (see
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Note the current interface cable connections to the ports on the RP.
Step 2
Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP
Step 3
interface.
Repeat
Step 4
to Step
Step 5 Loosen the captive installation screw on the cable-management tray and remove the tray from the chassis
(see
OL-26701-02
Cable-Management Tray Installation and Removal
Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed
5.
Figure 3-7).
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Cable Management
1
Figure 3-7).
Figure 3-7):
3-13