Using Show Commands To Display Spa Information - Cisco ASR-1000-SIP10 Hardware Installation Manual

SPA Blank Filler Plates
Note
For more information about FPD upgrades, refer to the "Upgrading Field-Programmable
Devices" chapter of the
Configuration
Use the show version command to obtain a few details on the installed SIPs and interfaces.
Step 5

Using show Commands to Display SPA Information

Table 6-1
Table 6-1
Command
show controllers type
slot/subslot/port
show diag
show hw-module subslot all fpd
show hw-module subslot all oir
show interfaces type
slot/subslot/port
show platform
show running-config
show version
SPA Blank Filler Plates
SPA blank filler plates are available to fill an unused SPA subslot.
When a SPA subslot is not in use, a SPA blank filler plate must be installed in the empty subslot to allow
the router or switch to conform to electromagnetic interference (EMI) emissions requirements and to
allow proper airflow across the SPAs. If you plan to install a new SPA in a subslot that is not in use, you
must first remove the SPA blank filler plate.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
6-6
If a SPA does not meet the minimum FPD version required, it will be updated automatically. If
the update fails, the failing SPA will be powered down and an error message will be reported on
the system console.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software
Guide.
describes the show commands you can use to display SPA information.
show Commands to Display SPA Information
Chapter 6
Type of Information Provided
Network link status, register contents, and controller chip
errors.
SPA type in that slot, number of ports, hardware revision, part
number, and EEPROM contents.
FPD version information of SPAs in the system.
The operational status of all SPAs in the system.
Line status and data link protocol status for a particular SPA
port. Statistics about data traffic sent and received by the port.
Information about the router. Provides operational status of a
SIP or SPA.
The router's running configuration and interfaces available in
the system.
Cisco IOS software version, names and sources of
configuration files, and boot images.
Installing and Removing a Shared Port Adapter
OL-14126-03