Powering On The Router - Cisco ASR 9001-S Hardware Installation Manual

Chapter 3 Installing Modules and Cables in the Chassis
Figure 3-12 Typical Power Connections for a Single DC Power Module
Step 4 Proceed to the

Powering on the Router

Use this procedure to turn on power to either an AC-powered or DC-powered router:
Step 1 Power on the circuit breaker to your power sources.
Step 2 Verify that the Power Input LED on each power module is lit.
Step 3 Set the power switch to the ON position.
Verify that the Green Power LED on each power module is lit.
Step 4
OL-26701-02
"Powering on the Router" section on page
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Powering on the Router
3-21.
3-21