Cisco ASR 9001-S Hardware Installation Manual page 55

Chapter 3 Installing Modules and Cables in the Chassis
When the system has reinitialized all interfaces, the modular port adapter (MPA) STATUS LEDs should
be on (green). The port LEDs (C/A and A/L) may be on (green), depending on your connections and
configuration.
Use this procedure to verify that a modular port adapter (MPA) is installed correctly:
Observe the console display messages and verify that the system discovers the modular line card (MLC),
Step 1
while the system reinitializes each interface, thus:
•
Step 2 When the modular port adapter (MPA) STATUS LEDs are green, all associated interfaces are
configurable.
•
•
If the modular port adapters (MPAs) do not become active within three minutes, refer to the system
Step 3
console messages. If there is no indication that a field-programmable device (FPD) upgrade is underway,
see
Using show Commands to Verify Modular Port Adapter (MPA) Status
This procedure uses show commands to verify that the new modular port adapters (MPAs) are configured
and operating correctly.
Use the show running-config command to display the system configuration. Verify that the
Step 1
configuration includes the new modular port adapter (MPA) interfaces.
Use the show diag command to display information about the installed modular line cards (MLCs).
Step 2
Use the show hw-module fpd location <rack/slot/subslot> command to verify the FPD version
Step 3
information of the modular port adapters (MPAs) installed in the system.
Note
Step 4 Use the show platform command to check the state of all boards in the chassis, including the modular
line card (MLC) and the modular port adapters (MPAs).
The modular port adapter (MPA) state should be "OK" and the modular line card (MLC) card state
should be "IOS XR RUN" in the show platform command output.
OL-26701-02
As a modular port adapter (MPA) is initialized, the STATUS LED will first be amber, indicating that
power is on. When the modular port adapter card (MPA) is active, the STATUS LED will illuminate
green.
If a modular port adapter (MPA) is replaced with a module of the same type (as in an OIR or
hardware swap), the previous configuration is reinstated when the modular port adapter (MPA)
becomes active.
If a modular port adapter (MPA) has not been previously installed in the same slot or subslot, then
the configuration for all associated interfaces is empty.
New interfaces are not made available until you configure them.
Note
Troubleshooting the Installation.
If a modular port adapter (MPA) does not meet the minimum version required, the FPD may need
to be updated. Refer to Cisco ASR 9000 Series Aggregation Services Router System Management
Configuration Guide for instructions. If the update fails, the failing module is powered down and
an error message displays on the system console.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Installing and Removing Modular Port Adapters
3-9