Cisco ASR 9001-S Hardware Installation Manual page 44

Rack-Mounting the Router Chassis
Use this procedure to install the chassis in the equipment rack:
With two people's aid, lift the chassis into the rack holding top and bottom of the chassis (see
Step 1
Figure
Figure 2-4
Do not grasp air inlet or exhaust when lifting the router chassis.
Caution
Position the chassis until the rack-mounting flanges are flush against the mounting rails on the rack.
Step 2
Hold the chassis in position against the mounting rails while the second person finger-tightens a screw
Step 3
to the rack rails on each side of the chassis.
Finger-tighten two more screws to the rack rails on each side of the chassis. Space the screws evenly
Step 4
between the top and bottom of the chassis.
Step 5 Attach the side brackets to the left and right side of the chassis by finger-tightening two screws through
each bracket into the chassis.
Step 6 Attach the side bracket front flanges to the rack by finger-tightening two screws through each bracket
flange into the front mounting rails of the rack.
Step 7 Fully tighten both the screws on the chassis mounting flanges on each side to secure the chassis to the
rack rails.
Fully tighten the two screws on each side bracket to secure the brackets to the chassis.
Step 8
Step 9 Fully tighten the two screws on each side bracket flange to secure the brackets to the rack rails.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
2-6
2-4).
Correct Lifting Positions
Chapter 2 Unpacking and Installing the Chassis
OL-26701-02