Chapter 5
Replacing Cisco ASR 9001 Router Components
Figure 5-2
Installing an AC or DC Power Module
To install an AC or DC power module (see
Slide the power module into the bay until it mates with its backplane connector.
Step 1
Make sure that keying lever locks with the chassis.
Step 2
Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator
Step 3
does not light up, see the
Removing a Chassis from the Equipment Rack
Use this procedure to remove the chassis and its components from the equipment rack:
You must use two people to remove the chassis from the equipment rack safely. An empty chassis can
Warning
weigh up to approximately
Step 1
Power off the router (see the
Step 2
Power off the circuit breakers to the power supplies.
OL-26701-02
Removing or Installing an AC or DC Power Module
"Troubleshooting the Power Subsystem" section on page
24.69 pounds (11.2 kg) .
"Powering Off the Router" section on page
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Removing a Chassis from the Equipment Rack
Figure
5-2):
4-3.
5-2).
5-5