Signal Description - Floppy Connector (Cn2); Power On Connector (Cn3); Reset Connector (Cn4) - Intel ECB-862 Series User Manual

User's Manual
3.9.7 Signal Description – Floppy Connector (CN2)
RDATA# The read data input signal from the FDD.
WD# Write data. This logic low open drain writes pre-compensation serial data to the selected FDD.
An open drain output.
WE# Write enable. An open drain output.
MOA# Motor A On. When set to 0, this pin enables disk drive 0. This is an open drain output.
MOB# Motor B On. When set to 0, this pin enables disk drive 1. This is an open drain output.
DSA# Drive Select A. When set to 0, this pin enables disk drive A. This is an open drain output.
DSB# Drive Select B. When set to 0, this pin enables disk drive B. This is an open drain output.
SIDE1# This output signal selects side of the disk in the selected drive.
DIR# Direction of the head step motor. An open drain output
Logic 1 = outward motion
Logic 0 = inward motion
STEP# Step output pulses. This active low open drain output produces a pulse to move the head to
another track.
DRVDEN0# This output indicates whether a low drive density (250/300kbps at low level) or a high drive
density (500/1000kbps at high level) has been selected.
TRAK0# Track 0. This Schmitt-triggered input from the disk drive is active low when the head is
positioned over the outermost track.
INDEX# This Schmitt-triggered input from the disk drive is active low when the head is positioned over
the beginning of a track marked by an index hole.
WP# Write protected. This active low Schmitt input from the disk drive indicates that the diskette is
write-protected.
DSKCHG# Diskette change. This signal is active low at power on and whenever the diskette is removed.
3.9.8

Power On Connector (CN3)

3.9.9

Reset Connector (CN4)

30 ECB-862/862L User's Manual
SIGNAL PIN
GND 2
PWRBTN 1
SIGNAL PIN
GND 2
RSTIN 1