Table of Contents
Advertisement
User's Manual
4.5.2.2
IDE Adapters
The IDE adapters control the hard disk drive. Use a separate sub menu to configure each
hard disk drive.
Figure 2 shows the IDE primary master sub menu.
Use the legend keys to navigate through this menu and exit to the main menu. Use Table
3 to configure the hard disk.
Item
IDE HDD Auto-detection
IDE Primary Master
Capacity
Access Mode
The following options are selectable only if the 'IDE Primary Master' item is set to 'Manual'
Cylinder
Head
Precomp
Landing zone
Sector
46 ECB-862/862L User's Manual
Options
Press Enter
None
Auto
Manual
Auto Display your disk drive
size
Normal
LBA
Large
Auto
Min = 0
Max = 65535
Min = 0
Max = 255
Min = 0
Max = 65535
Min = 0
Max = 65535
Min = 0
Max = 255
Table3 Hard disk selections
Description
Press Enter to auto-detect the HDD on
this channel. If detection is successful, it
fills the remaining fields on this menu.
Selecting 'manual' lets you set the
remaining fields on this screen. Selects
the type of fixed disk. "User Type" will let
you select the number of cylinders,
heads, etc. Note: PRECOMP=65535
means NONE !
Disk drive capacity (Approximated).
Note that this size is usually slightly
greater than the size of a formatted disk
given by a disk checking program.
Choose the access mode for this hard
disk
Set the number of cylinders for this hard
disk.
Set the number of read/write heads
**** Warning: Setting a value of 65535
means no hard disk
****
Number of sectors per track
Advertisement
Table of Contents
