Display Switch Is Set Incorrectly; Display Type Has Changed Since Last Boot; Eisa Configuration Checksum Error Please Run Eisa Configuration Utility; Eisa Configuration Is Not Complete Please Run Eisa Configuration Utility - Intel ECB-862 Series User Manual

User's Manual

Display Switch Is Set Incorrectly

Display switch on the motherboard can be set to either monochrome or color. This
indicates the switch is set to a different setting than indicated in Setup. Determine which
setting is correct, and then either turn off the system and change the jumper, or enter
Setup and change the VIDEO selection.

Display Type Has Changed Since Last Boot

Since last powering off the system, the display adapter has been changed. You must
configure the system for the new display type.
EISA Configuration Checksum Error
Please Run EISA Configuration Utility
The EISA non-volatile RAM checksum is incorrect or cannot correctly read the EISA slot.
This can indicate either the EISA non-volatile memory has become corrupt or the slot has
been configured incorrectly. Also be sure the card is installed firmly in the slot.
EISA Configuration Is Not Complete
Please Run EISA Configuration Utility
The slot configuration information stored in the EISA non-volatile memory is incomplete.
Note: When either of these errors appear, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.

Error Encountered initializing Hard Drive

Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables are
correctly and firmly attached. Also be sure the correct hard drive type is selected in Setup.

Error Initializing Hard Disk Controller

Cannot initialize controller. Make sure the cord is correctly and firmly installed in the bus.
Be sure the correct hard drive type is selected in Setup. Also check to see if any jumper
needs to be set correctly on the hard drive.

Floppy Disk Cntrlr Error Or No Cntrlr Present

Cannot find or initialize the floppy drive controller. Make sure the controller is installed
correctly and firmly. If there are no floppy drives installed, be sure the Diskette Drive
selection in Setup is set to NONE.
94 ECB-862/862L User's Manual