M-Systems' Diskonchip Flash Disk; Installing Doc; Installing The Single Board Computer - Intel ECB-862 Series User Manual

Intel pentium ii full-size picmg cpu card with 4 usb 2.0, audio, & dual 10/100 base-tx ethernet

Table of Contents

3.5

M-Systems' DiskOnChip Flash Disk

ECB-862 reserves a 32-pin DIP socket to support M-Systems' DiskOnChip flash disk up to

1 GB. The DiskOnChip is based on pure ISA bus and without PnP (Plug and Play) function.

Before the installation, make sure that the DiskOnChip I/O address jumper is set properly

to prevent the I/O resource conflict.

3.5.1

Align the DOC with the pinholes on the socket. Make sure that the notched corner or dot

mark (pin 1) of DOC corresponds to notched corner of the socket. Then press the DOC

gently until it fits into place. If installation procedure is correct, the flash disk can be viewed

as a normal hard disk to access read/write data now.

Note:

Please make sure that your DOC is properly inserted. Place the DOC in wrong

direction will damage the flash device.

If you system would like to boot from the flash disk, it is recommended to refer to the

application note provided by M-Systems first. You can easily obtain the application note

from M-Systems' DiskOnChip user's manual or from their web site as below.

3.6

To install your ECB-862 into chassis or proprietary environment, the following steps have

to be followed.

Make sure all jumpers are properly set.

Install and configure CPU and memory module correctly.

Place the ECB-862 into the dedicated position in your system.

Attach cables to peripherals.

Note:

Please ensure that your SBC is properly installed and fixed by mechanism.

Otherwise, the system might be unstable or do not work due to bad contact of

golden finger and slot.

http://www.m-sys.com

ECB-862/862L User's Manual 15

ECB-862/862L

Table of Contents