Configuring A Description For An Aggregation Group - 3Com 4500 Configuration Manual

You need to enable LACP on the ports which you want to participate in dynamic aggregation of the
system, because, only when LACP is enabled on those ports at both ends, can the two parties reach
agreement in adding/removing ports to/from dynamic aggregation groups.
You cannot enable LACP on a port which is already in a manual aggregation group.
Follow these steps to configure a dynamic LACP aggregation group:
To do...
Enter system view
Configure the system priority
Enter Ethernet port view
Enable LACP on the port
Configure the port priority
Changing the system priority may affect the priority relationship between the aggregation peers, and
thus affect the selected/unselected status of member ports in the dynamic aggregation group.

Configuring a Description for an Aggregation Group

To do...
Enter system view
Configure a description for an
aggregation group
Use the command...
system-view
lacp system-priority
system-priority
interface interface-type
interface-number
lacp enable
lacp port-priority
port-priority
Use the command...
system-view
link-aggregation group agg-id
description agg-name
1-8
Remarks
—
Optional
By default, the system priority is
32,768.
—
Required
By default, LACP is disabled on a
port.
Optional
By default, the port priority is
32,768.
Remarks
—
Optional
By default, no description is
configured for an aggregation
group.