Setting To Output System Information To A Log Host - 3Com 4500 Configuration Manual

To do...
Enable trap information terminal
display function
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.

Setting to Output System Information to a Log Host

Follow these steps to set to output system information to a log host:
To do...
Enter system view
Enable the information
center
Enable information
output for a specified
switch in a fabric
Enable system
information output to a
log host
Configure the source
interface through which
log information is sent to
the log host
Configure the output
rules of system
information
Set the format of the time
stamp to be sent to the
log host
Use the command...
terminal trapping
Use the command...
system-view
info-center enable
info-center switch-on { unit
unit-id | master | all }
[ debugging | logging |
trapping ]*
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost source
interface-type
interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
info-center timestamp
loghost { date |
no-year-date | none }
1-11
Remarks
Optional
Enabled by default
Remarks
—
Optional
Enabled by default.
Optional
By default, debugging information output
is enabled, and log and trap information
output are disabled for the master switch
in a fabric. Debugging, log and trap
information output are all disabled for
other switches in the fabric.
Required
By default, the switch does not output
information to the log host.
After you configure the switch to output
information to the log host, the switch
uses information channel 2 by default.
Optional
By default, no source interface is
configured, and the system
automatically selects an interface as the
source interface.
Optional
Refer to Table 1-4 for the default output
rules of system information.
Optional
By default, the time stamp format of the
information output to the log host is date.