Displaying And Maintaining Qos - 3Com 4500 Configuration Manual

For information about the mirroring-group monitor-port command and the monitor-port command,
refer to the part talking about mirroring.
Configuration example
Network requirements:
Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Duplicate the packets from network segment 10.1.1.0/24 to the destination mirroring port Ethernet
1/0/4.
Configuration procedure:
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/4
[Sysname-Ethernet1/0/4] monitor-port
[Sysname-Ethernet1/0/4] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] mirrored-to inbound ip-group 2000 monitor-interface

Displaying and Maintaining QoS

Display the mapping between 802.1p
priority and local precedence
Display the priority marking
configuration
Display the protocol packet priority
configuration
Display line rate configuration
Display traffic policing configuration
Display VLAN mapping configuration
Display queue scheduling configuration
Display traffic mirroring configuration
Display all the QoS configuration
To do... Use the command...
display qos
cos-local-precedence-map
display qos-interface { interface-type
interface-number | unit-id }
traffic-priority
display protocol-priority
display qos-interface { interface-type
interface-number | unit-id } line-rate
display qos-interface { interface-type
interface-number | unit-id } traffic-limit
display qos-interface { interface-type
interface-number | unit-id }
traffic-remark-vlanid
display queue-scheduler
display qos-interface { interface-type
interface-number | unit-id } mirrored-to
display qos-interface { interface-type
interface-number | unit-id } all
1-23
Remarks
Available in
any view