To do...
Enter system view
Set the XRN fabric
authentication mode for the
switch
When an XRN fabric operates normally, you can regard the whole fabric as a single device and perform
configuration on it. Multiple switches constitute an XRN fabric. Therefore, data transmission and
simultaneous program execution among the switches may cause the XRN fabric in a busy situation.
When you configure the XRN fabric, you may receive a prompt "Fabric system is busy, please try
later..." which indicates the fabric system does not perform your configuration properly. In this case, you
need to verify your previous configuration or perform your configuration again.
Displaying and Maintaining XRN Fabric
To do...
Display the information about
an XRN fabric
Display the topology
information of an XRN fabric
Clear the FTM statistics
XRN Fabric Configuration Example
Network Requirements
Configure unit ID, unit name, XRN fabric name, and authentication mode for four switches to enable
them to form an XRN fabric as shown in
The configuration details are as follows:
Unit IDs: 1, 2, 3, 4
Unit names: unit 1, unit 2, unit 3, unit 4
Fabric name: hello
Authentication mode: simple password
Password: welcome
Use the command...
system-view
xrn-fabric
authentication-mode { simple
password | md5 key }
Use the command...
display xrn-fabric [ port ]
display ftm { information |
topology-database }
reset ftm statistics
Figure
1-3.
1-9
Remarks
—
Optional
By default, no authentication
mode is set on a switch.
Remarks
Available in any view
Available in user view