3Com 4500 Configuration Manual page 336

AAA
configuration
Creating an ISP Domain and Configuring Its Attributes
Follow these steps to create an ISP domain and configure its attributes:
To do...
Enter system view
Create an ISP domain or set an
ISP domain as the default ISP
domain
Set the status of the ISP
domain
Set the maximum number of
access users that the ISP
domain can accommodate
Set the idle-cut function
Set the accounting-optional
switch
Task
Creating an ISP Domain and Configuring Its
Attributes
Configuring separate AAA schemes
Configuring an AAA Scheme for an ISP
Domain
Configuring Dynamic VLAN Assignment
Configuring the Attributes of a Local User
Cutting Down User Connections Forcibly
Use the command...
system-view
domain { isp-name | default
{ disable | enable isp-name } }
state { active | block }
access-limit { disable |
enable max-user-number }
idle-cut { disable | enable
minute flow }
accounting optional
Required
Required
Required
With separate AAA schemes, you
can specify authentication,
authorization and accounting
schemes respectively.
You need to configure RADIUS or
HWATACACS before performing
RADIUS authentication.
Optional
Optional
Optional
—
Required
If no ISP domain is set as the
default ISP domain, the ISP
domain "system" is used as the
default ISP domain.
Optional
By default, an ISP domain is in
the active state, that is, all the
users in the domain are allowed
to request network service.
Optional
By default, there is no limit on
the number of access users
that the ISP domain can
accommodate.
Optional
By default, the
accounting-optional switch is
off.
2-2
Remarks
Remarks
Optional
By default, the idle-cut function
is disabled.