EPSON Stylus Pro 7000
1.4 Control Panel
This section describes the control panel, the buttons, the lights, and the way
you make settings.
Figure 1-6. Control Panel
BUTTONS
All eight buttons on the control panel and their functions are described below.
Product Description
Table 1-22. Buttons and Functions
Button
(Second function)
Power
• Switch -pause/ready
Pause
(Reset)
• Reset (press 3 seconds)
• Enters SelecType mode
• Opens Cutter
SelecType
Replacement Menu
(press for five seconds)
Selects *1
• Auto Cut
Cut/Eject
(Enter)
• Cutter Off
• Sheet
Paper Feed ↑
Feeds paper backward *2
Paper Feed ↓
Feeds paper forward *3
Paper Source
Selects paper source
(Item)
Cleans both heads (press
Cleaning
for three seconds)
Paper Source +
Cut/Eject +
Paper Feed ↓
Paper Source +
Cut/Eject +
Cleaning
Notes:
1: Interrupts ink drying and runs the specified operation.
2: 1.27cm/second paper feed for 2 seconds after key is pressed. 7.62cm/second
paper feed if pressed for over two seconds. Maximum feed of 20cm with one
press of the button.
3: 1.27cm/second paper feed for 2 seconds after key is pressed. 7.62cm/second
paper feed if pressed for over two seconds.
Control Panel
Function
SelecType
(Normal)
Function
Power on/off
N/A
N/A
Selects menu or
major category
Confirms and saves
setup values
Cycles backward/
increases value
Cycles forward/
decrease value
Selects item or
minor category
N/A
N/A
Revision B
Power-On
Function
N/A
Maintenance
Mode
N/A
Maintenance
Mode 2
Firmware
Update
Mode
34