Control Panel Messages - Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual

EPSON Stylus Pro 7000

1.4.2 Control Panel Messages

Table 1-28. Paper Source Indicator
Printer Status
Selected paper source
Fatal error
Roll paper and sheet sizes are different
Reset, timer IC reset/NVRAM clear
Printer status and error messages appear on the control panel display. The
table below lists the messages.
Table 1-29. Control Panel Messages
Display Message
Fatal error - see "Service Requests" on
SERVICE REQ. nnnnnnnn
page 48
Turn the printer off and on to reinitialize
TURN PWR OFF AND ON
In the process of re-initializing.
RESET
TRANSPORT PREP nn% See "Transportation Mode" on page 53
POWER OFF Preparing to shut down.
The cover is open. The carriage stops in place,
and the printhead can be damaged if the head
COVER OPEN
remains out of the capped position for a long
period of time.
Paper Set lever is in the released and cannot
continue or begin a print, cleaning, or
SECURE PAPER LEVER
initialization sequence.
One or more cartridges are not installed
NO INK CARTRIDGE
An unsupported Type-B interface card is
OPTION I/F ERROR
installed.
• A predetermined amount of ink has been
INK OUT
• A near-end cartridge has been removed and
Product Description
Indicator
On
Flashing
Flashing
On
Meaning
consumed after the cartridge has entered
the near-end condition.
re-installed.
Table 1-29. Control Panel Messages (continued)
Display Message
READY *
WAIT *
INK CHARGING nnn%
INK DRY xx MIN *
PRESS PAUSE BUTTON
LOAD xxx PAPER
LOAD PAPER
PAPER JAM
PAPER NOT CUT
PAPER NOT STRAIGHT
Control Panel
Revision B
Meaning
Can receive and print data.
Resetting Timer IC
Clearing NVRAM
Performing reset operation
Performing ink sequence operation
Initializing the printer
Initializing the paper
Initial charging of ink - shown in percent
completed
Printer waits xx minutes before the next print
job to allow enough time for ink to dry on
previous print job.
Waiting for paper initialize start trigger
Wrong paper loaded or wrong paper source
selected on control panel.
The Paper Set Lever is in the released position
(before printing). Pull the Paper Set lever
forward to the set position
Both front and rear paper sensors detect paper
and there is a carriage over-current or out of
step error. This is due to:
• Paper is jammed inside the printer
• Paper is obstructing the carriage path
during feeding or cutting operation.
Printer did not cut the paper completely, or the
cut piece still remains over the paper sensor
Paper skewed more than 3mm between the
leading and following edges. Check the
printout for skew and make sure no ink was
fired onto the platen.
37