Troubleshooting Using The Error Messages - Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual

EPSON Stylus Pro 7000
3.2 Troubleshooting Using the Error
Messages
The EPSON Stylus Pro 7000 performs self-diagnostic tests using the data
supplied by its various sensors, and if an error is detected by one or more
sensors, a corresponding error message appears on the control panel display.
No matter what kind of error occurs, use Table 3-2, "LCD Panel Error
Messages," on page 83 or Table 3-3, "Messages That Indicate Service is
Necessary," on page 84 to determine what and where the problem is, as well
as where to look for directions on fixing the problem.
Table 3-2 lists the printer errors that users can check and troubleshoot
by themselves.
Table 3-3 lists the printer errors that require service technicians to
check and troubleshoot, such as failed part replacement.
Table 3-2. LCD Panel Error Messages
LCD message
Ink Cartridge
Ink End, Wrong Ink Cartridge
Replace
Ink Drying nn min. Ink drying
Ink Low Ink low
Ink Charge nnn Initial Ink Charge
Replace Ink
Performing ink cartridge replacement
Cartridge
Press Pause Waiting for the paper-initialization trigger Status
Ready Printer is ready
Cannot Print There is a problem.
Printing Printing the current print job.
Option I/F Error Type-B interface error
No Cartridge One or more ink cartridges not installed
Troubleshooting
Status Type
Error
Status
Warning
Status
Error
Status
Error
Status
Error
Error

Troubleshooting Using the Error Messages

Table 3-2. LCD Panel Error Messages
LCD message
Cover Open The cover is open
Turn off/on The printer needs to re-initialize.
Service Call
Fatal error occurred
nnnnnnnn
Initializing printer, initializing paper,
Please Wait charging ink, resting timer IC, or clearing
NVRAM
Power Off Performing power-off sequence
Pause Printer paused
Maintenance Call Maintenance required (waste ink pad
nnnn replacement)
Transportation
Draining transport fluid (100% = end)
Refer to
Prep nn%
page
Paper Not Cut Paper cut error
Paper Skew Paper fed at a slant
Paper Jam Paper jam occurred
Load Paper No paper loaded or roll paper end
85
The Paper Set Lever was moved to the
Return Paper
Released position during printing and
Lever
must be returned to the Set position.
90
Paper is loaded but the Lever is not in the
Set Paper Lever
Set position. Move to the Set position.
Please Reload Paper recognition error or paper feed/exit
Paper error (cut sheets only)
91
Paper is too thick for cleaning and must
Remove Paper
be removed for cleaning.
91
Reset Re-initializing the printer
91
Please Load xxx Roll paper/cut sheet size error
Revision B
Status Type
Error
Status
Error
Status
Status
Status
Warning
Status
Error
Error
Error
Error
Error
Error
Error
Error
Status
Error
Refer to
page
88
92
86
88
89
87
87
90
89
87
83