Errors - Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual

EPSON Stylus Pro 7000
Table 3-6. Maintenance Call nnnn
Item
Maintenance Call nnnn
LCD
nnnn = the replacement part code (see "Service Call 00000100"
message
on page 93)
LED indicator
No change.
status
Maintenance required. The corresponding part described by the
Details nnnn has almost reached the end of its effective life. Service is
required.
Replace the old part(s) with new ones (Maintenance Kit 1054038)
Recovery
and reset the corresponding counters (Waste Ink and Cleaning).
Troubleshooting
Description
Troubleshooting Using the Error Messages

ERRORS

Error messages appear on the LCD to notify the user that the printer cannot
print properly under the current conditions. When an error message appears,
printing stops and data transfer from the host PC stops. (The parallel interface
signal = /ERROR -> "LOW" and BUSY -> "HIGH" and data cannot be entered.)
Table 3-7. No Paper Loaded
Item
LCD
No Paper Loaded
message
LED indicator
Paper Check indicator is on
status
No paper loaded or the end of the roll paper.
When printing on roll paper, if the Paper End sensor detects the
end of the roll paper, paper feeding stops and the paper is held
Details in place.
When printing on cut sheets, if the Paper End sensor detects the
end of the paper, printing as well as feeding stop and the paper
is held in place.
Load paper.
For cut sheets, remove the printed sheet and load a new one.
After loading the new sheet, the error is cleared. If data from the
previous print job remains, the data is printed on the new sheet
Recovery according to the original paper-size data.
If this error occurs even if paper is properly loaded, check the P-
REAR sensor for obstruction or dust. Also make sure there is no
foreign material blocking the hole in the Paper Guide U where
the P-Rear sensor is located.
Revision B
Description
86