Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual page 130

EPSON Stylus Pro 7000
5. Remove one screw (CP(W) M3x6) securing the damper holder, unhook
the ink tubes from the damper holder, and then remove the damper
holder.
Ink tubes
Figure 4-34. Damper Holder
Disassembly & Assembly
Ink tubes
One
screw
Damper
holder
6. Pull out the dampers. To pull out the dampers, place the tip of a flat-head
screwdriver or similar tool under the protrusion on the left side of a
damper and steady the damper with the forefinger of your other hand.
Gently but firmly pull the damper straight out.
If you only need to replace one head, you only need to perform
the following steps in regards to that printhead.
B head = left side; B, C, M
C head = right side; LC, LM, Y
Do not squeeze the dampers and try to only touch the edges of
the dampers. If pressure is applied to the middle of the
dampers, the ink inside will squirt out.
dampers
Disassembly Flow
B head
C head
dampers
Figure 4-35. Damper Removal
Revision B
Screwdriver
130