Chapter 5
Setting Up Devices—CiscoWorks 1105/1130/1130-19
Table 5-4
Setup Procedures for Routers and Switches (continued)
Task
3. (Optional) Set
system name,
contact, and
location variables.
Setting Up AAA Servers
Note
Note
78-16345-01
Procedure
On IOS-based devices, enter configuration mode and use
the following commands to set the system name, system
contact, and system location:
hostname name
•
snmp contact contact
•
snmp location location
•
On Hybrid OS-based Catalyst switches, enter enable
mode and use the following commands to set the system
name, system contact, and system location:
set system name name command.
•
set system contact contact
•
•
set system location location
The WLSE can monitor the performance of AAA (Authentication, Authorization,
and Accounting) services provided by CiscoSecure ACS server and a Cisco
Access Registrar (CAR) RADIUS server. The services supported are LEAP,
RADIUS, EAP-MD5, and PEAP (EAP-GTC only).
This section covers setting up an ACS server. To set up a CAR server, see the CAR
documentation on Cisco.com.
For PEAP, besides the procedure in this section, you must set up a certificate and
private key on the ACS server and then enable PEAP. For more information, see
the CiscoSecure ACS documentation.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Setting Up AAA Servers
Notes
These variables make
the device more
manageable.
The system name,
system contact, and
location will appear
in the device detail
displays.
5-25