Cabling The Management Port; Verifying Management Interface Connectivity - Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual

Connecting the Management Interface

Cabling the Management Port

The SCE 2000 has two management ports, labeled Mng1 and Mng 2.
To cable the management port, complete the following steps:
Take the Ethernet cable provided (with attached RJ-45 connector) and plug it into the desired
Step 1
MNG port on the front panel of the SCE 2000, as shown in the following figure.
Figure 5-2: Cabling the Management Port
Step 2 Connect the other end of the Ethernet cable into your management network.
Make sure that you push on the RJ-45 connector attached to the cable until you hear a click,
which indicates that the connector is fully inserted and secured in the receptacle. Gently pull on
the plug to confirm whether the plug is locked into the socket.
If the Link LED on the SCE 2000 management port does not light, try removing the cable and
reinserting it firmly into the module socket. To disconnect the plug from the socket, press down
on the raised portion on top of the plug, releasing the latch. You should hear an audible click
indicating the latch has released. Carefully pull the plug out of the socket.
If the management port Link LED on the SCE 2000 still does not light, verify that the cable is
connected correctly to the appropriate network element on its second end.

Verifying Management Interface Connectivity

If the SCE 2000 platform has been powered up, test now to verify that connectivity has been
established between the SCE 2000 and the remote management host. If the SCE 2000 platform is
not powered up, perform this step after starting the SCE 2000 platform.
To verify that connectivity has been established between the SCE 2000 and the remote
management host, complete the following steps:
Step 1 After you connect the cable to the appropriate Mng port and to your network, check the relevant
Mng port LEDS.
There are two Mng LEDs: Link/Active, and 10/100/1000 (refer to Front Panel (on page 2-1)).
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
5-26
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
• If only one management port is used — connect the port directly to the LAN.
If both management ports are used — connect both ports to the LAN via a switch.
•
OL-7826-05