Configuring Infrastructure Access Points To Register With A Wireless Lan Services Module (Wsm); Configuring Scanning Aps - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Setting Up IOS Access Points
Configuring Infrastructure Access Points to Register with a Wireless LAN
Services Module (WSM)

Configuring Scanning APs

Note
Table 5-3 Setting Up Scanning APs Quick Reference
Task
Configure the scanning APs for basic
1.
management and radio management.
Do not configure VLAN/SSID on the
•
scanning AP.
Do not configure the scanning AP as
•
a WDS device.
Configure the specific scanning AP
2.
parameters.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-20
To configure infrastructure access points to register with a Wireless LAN
Services Module, see the relevant AP and WSM documentation on Cisco.com.
This section describes how to configure an AP as a scanning-only AP. After you
have performed the basic network management configuration and radio
management configuration described in this chapter, perform the additional
configuration described in this section to make the AP into a scanning AP.
Scanning APs can detect and report "bug-lighted" clients (clients associated to
unauthorized access points). Scanning APs do not accept client associations.
For more information on scanning APs and other requirements for using scanning
APs with a WLSE, see the online help "Radio Management" chapter in the User
Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Radio scanning requires a read/write SNMP community string on APs. For more
information, see Radio Management Setup—IOS Devices, page
Table 5-3 on page 5-20
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
lists the high level tasks for setting up scanning APs.
References
Setting Up IOS Access Points, page 5-4
Configuring a Scanning AP—Using the AP CLI,
page 5-21
Configuring a Scanning AP—Using a WLSE
Configuration Template, page 5-21
5-10,
78-16345-01